Reset an ACL to default values

Reset an ACL to change the ACL name to the default name and the filter ACL mode to a default of enable.

Procedure

Use the data in the following table to use filter acl command.


Variable	Value
`<1-2048>`	Specifies the ACL ID.
enable	Enables the ACL state, and all associated ACEs. Enabled is the default state.
matchType <both\|terminatingNNIOnly\|uniOnly>	For inVsn ACL types, specifies the match type to associate with the ACL. Valid options are: both for traffic ingressing on both UNI ports and network-to-network interface (NNI) ports terminating on this node terminatingNNIOnly for traffic ingressing on NNI ports only and terminating on this node uniOnly for traffic ingressing on UNI ports only The default value is both.
name `WORD<0-32>`	Specifies an optional descriptive name for the ACL.
type <inVlan\|inPort\|outPort\|inVsn>	Specifies the ACL type. The values inVlan, inPort, and inVsn are ingress ACLs, and outPort is an egress ACL. A port-based ACL has precedence over a VLAN-based ACL.